Weller WTCPT Bedienungsanleitung PDF herunterladen

WTCPT SOLDERING STATION

A transformer powered soldering station, complete with a lightweight,

heat insulated, low voltage, temperature controlled soldering iron.

The special Weller

closed loop method of controlling maximum tip

temperature sensitive components. The soldering iron features a

stainless steel, plug in heating element construction, a non-burning

silicone rubber cord, and a large selection of tips in sizes from 1/64

diameter to 15/64 diameter with a choice of tip temperature of

600°F, 700°F and 800°F. The soldering iron is normally provided with

a PTA7 1/16 screwdriver 700°F.

The station features a housing of an impact resistant polycarbonate

plastic for durability and protection against accidental damage, a

quick disconnect plug for the soldering iron, a lighted on-off switch,

and a flexible 3 wire power cord.

The plastic soldering iron holder can be used attached to either side

of the transformer case, or separated as shown. The iron holder

incorporates a water reservoir with wick to keep the tip wiping

sponge moist.

The station housing and hand piece are grounded with a separate conductor that terminates at the third pin on the power cord.

The Weller

units are UL listed.

WARNING: This product, when used for soldering and similar applications, produces chemicals known to the State of

California to cause cancer and birth defects or other reproductive harm.

SPECIFICATIONS

POWER UNIT

1. Power input: 120 VAC, 60 Hz, (240VAC ±10%, 50/60 Hz) 60 watts.

2. Power unit output voltage: isolated 24 VAC @ 1.75 amperes.

3. Size: 4.5 x 5.875 x 3.625.

4. Line Cord: 3 wire U.L. recognized.

SOLDERING IRON

1. Wattage: 42 watts.

2. Iron weight: 2 ounces

3. Recovery time (from 100°F drop) with PTA7 tip: 11 seconds.

4. Cord: Silicone rubber, burn resistant, 4 feet.

PRINCIPLE OF OPERATION

When the soldering tip is cold, a ferromagnetic temperature sensor (1) attached to the tip attracts a permanent magnet (2). The

magnet movement causes a shorting bar (4) to make contact with a set of isolated electrical contacts (3) thereby supplying

power to the heating element through the solder lugs (5). When the tip reaches its idle temperature, the sensor becomes

nonmagnetic and no longer attracts the magnet. Then a magnetic bushing (6) attracts the magnet causing the shorting bar to

break the circuit. In this manner, power to the heating element is turned on and off automatically.

CAUTION: Tip is grounded, do not solder an energized circuit.

1 2 3 4

Inhaltsverzeichnis

Seite 1 - WTCPT SOLDERING STATION

WTCPT SOLDERING STATIONA transformer powered soldering station, complete with a lightweight,heat insulated, low voltage, temperature controlled solder

Seite 2 - CARE OF WELLER

WTCPT OPERATING INSTRUCTIONSUnpack unit carefully. Place spring and funnel in slot in top of tool stand. Attach tool stand to either side of power uni

Seite 3 - WTCPT TROUBLESHOOTING GUIDE

WTCPT TROUBLESHOOTING GUIDEWARNING: AC line voltage is present inside power unit even when power switch is off. Refer service to qualified personnel.N

Seite 4 - OPTIONAL PARTS FOR THE WTCPT

CUSTOMER SERVICEShould your WTCPT require repair, it may be sent to the following address:Cooper Hand Tools Division815 State RoadCheraw, SC 29520AT